Aja V2Digital Manuel d'utilisateur télécharger pdf (Page 7)

V2Digital v1.0 www.aja.com

Chapter 2: Operation

Default Operational Settings

The V2Digital converter ships from the factory with the following configuration:

• Local (DIP switch) control

• Component video input

• YPbPr format

•Pedestal Off

If these settings apply to your requirements, you can simply connect the video input and

output signal cables and power up the V2 Digital unit.

For other applications, you can configure the unit using its DIP switch settings, or by

using MiniConfig and a PC or Mac via USB. When configured for “component” V2DIGITAL

will auto detect between various component standards.

DIP Switch Settings

Four DIP switches are located on the bottom of the unit. The label on the bottom of the

unit identifies the functions of the switch positions. The default shipping position for

these switches is Off (down). By default, DIP switch configuration is enabled, and

MiniConfig control is disabled.

Use a pen-point or paper clip to change DIP switch positions.

Figure 2. DIP Switches.

NOTE: BetaJ is only accessible via MiniConfig.

Table 1. DIP Switch Setting Descriptions

SWITCH FUNCTION OFF (Down) ON (Up)

1 Control Selects Local (DIP), and blocks

MiniConfig control

Selects Remote

(MiniConfig), and disables

DIP switches 2-4.

2 Input Selects Component Selects Composite

3 Color Space Selects YPbPr in Component

mode, S-Video in Composite

mode

Selects RGB in Component

mode, Composite in

Composite mode

4 Pedestal Selects Off Selects On

OFF

DIP Switches

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Pas de commentaire

Aja V2Digital Manuel d'utilisateur Page 7